Buying and weights
- FETFederal excise tax
- A federal tax on new trailers. It is 12 percent of the trailer base price plus any add-ons the shop installs. Freight is not part of the base. Pre-owned units normally carry no FET.
- +FETPrice before FET
- A price followed by +FET is the price before the federal excise tax. The tax is added on the quote.
- OALOverall length
- The total length of the trailer from front to back.
- GVWRGross vehicle weight rating
- The most the whole trailer is rated to weigh, trailer and load together. On many models GAWR and GVWR set the legal payload. On others the factory names GAWR and the tire ratings. Ask us for the figure on a model.
- GAWRGross axle weight rating
- The most one axle is rated to carry.
Trailer types
- Removable gooseneck (RGN)
- A lowboy whose neck detaches, so the load drives straight onto a low deck.
- Double drop or lowbed
- A fixed deck trailer with a dropped well between the gooseneck and the rear axles.
- Step deck
- A two level deck, an upper deck and a lower deck, with no full drop. It hauls taller freight than a flatbed.
- Flatbed or platform
- One flat, level deck with no sides and no drop.
- Extendable
- A deck that telescopes out for over-length loads. The base can be a step deck, a platform or a double drop.
- Traveling axle
- The deck tilts and the axle assembly travels forward and back, so the trailer loads at ground level with no ramps.
- Sliding axle
- The rear axle slides back and the deck tilts, so the trailer loads at ground level.
- Traveling or hydraulic tail
- A folding or hydraulic rear tail that works as a ramp, so the trailer loads itself.
- Paver special
- A low profile deck built to haul asphalt pavers.
- Tag trailer
- A towed helper or equipment trailer with no gooseneck.
- Jeep or booster
- A helper axle or dolly that rides ahead of a lowboy (a jeep) or behind it (a booster). It is an add-on, not a trailer on its own.
- Flip axle
- A fourth axle that deploys for weight distribution and compliance. It is an add-on for extra capacity.
Parts and measurements
- ABSAnti-lock brake system
- Electronic braking that keeps the wheels from locking up.
- Gooseneck
- The forward extension of the trailer that connects to the tractor.
- Kingpin
- The pin that connects the tractor fifth wheel to the gooseneck.
- Swing radius
- The distance from the kingpin to the side of the gooseneck as it swings in a turn. A flip box can add to it.
- Flip box
- A removable extension that adds to the swing radius of the gooseneck.
- Bogie
- The rear wheel assembly: axles, suspension and brakes. A fixed bogie is welded to the deck. A modular bogie is pinned to it, so the deck can be swapped.
- Tridem
- A three axle configuration.
- Axle spread
- The distance between axle centers, for example 54.5 in or 60 in.
- Modular deck
- Deck sections you can swap to suit the load. Fontaine says modular decks let you switch out deck types or add deck inserts, and that fixed decks are welded to the bogie and cannot be swapped.
- Beam deck
- A deck made of two beams, not a full width deck. The width quoted for a beam deck trailer is the bogie width, for example 8 ft 6 in.
- Deck height
- The distance from the ground to the deck surface, measured loaded.
- Ground clearance
- The distance from the ground to the lowest point of the trailer.
- Pony motor
- A small engine that runs the trailer hydraulics when the tractor does not. On Fontaine it is a 13 HP gasoline powered auxiliary hydraulic power unit.
- Wet line operation
- The gooseneck hydraulics run from the tractor, not from a pony motor.
- Hub-piloted wheels
- A wheel mounting system where the wheel bears on the wheel studs.
Fontaine model letters
- FLDFlat level deckFontaine term
- A standard flat deck.
- DSRDrop side rail deckFontaine term
- A deck with side rails that drop down.
- LCCLow close coupledFontaine term
- A close coupled axle layout with a lower deck height.
- MFLD, MDSR, MBMDModular flat level deck, modular drop side rail deck, modular beam deckFontaine term
- The same deck styles on a modular bogie. MBMD is the modular beam deck, with center beams only.
- HRG, MRGHydraulic removable gooseneck, mechanical removable gooseneckFontaine term
- HRG is a hydraulic detachable gooseneck connection. MRG is a mechanical one.
- MXExtendable MagnitudeFontaine term
- A flat level telescopic deck on a modular tridem bogie, for example the 55MX and the 60HD MX.
- PVRPaver and rollerFontaine term
- A configuration built for road equipment such as pavers.
- AGAgricultureFontaine term
- A configuration for hauling farm equipment.
- EQ1, EQ2, EQ3Fontaine term
- Hydraulic spreader systems with a self contained power unit. EQ1 is a single axle system for the Magnitude 55 and 60 class. EQ2 is a tandem axle system for the Magnitude 60HD, 60HD MX, 65 and 75. EQ3 has one fixed axle and is for the Magnitude 80.
- 3+1, 3+2, 3+3Fontaine term
- How Fontaine names Magnitude axle layouts. The 60 is a 3+1. The 60HD, 65 and 75 are a 3+2, five axles in total. The 80 is a 3+3, six axles in total. Each model page lists its own axles.
Not sure what a term means on a model or a quote? Ask us. Specs on a model page come from the factory.
